Change a Propane Tank
Forklifts powered by propane are common inside warehouse settings. These forklifts have a propane mount situated at the back of the operator. These tanks need to be replaced periodically as they have limited lifespans. Operators of forklifts should always use caution when handling propane tanks. Compressed gases are hazardous, especially because the gas is flammable. Utilize care when removing and replacing propane tank to prevent injury.
1 To change a propane tank, first stop the lift truck while leaving the engine running, and turn the valve on the tank off. Let the forklift run until the engine dies. This process burns off the gas in the transfer hose that connects the tank and the engine. Before taking the next steps, put on the proper safety equipment, like insulated gloves made of either neoprene or leather. It is very essential for you to protect your skin from touching the compressed gas, which is very cold.
2 Disconnect the hose from the tank and take off the holding straps to remove the tank. When putting in a new tank, tighten the nut to reattach the holding straps and to reattach the hose at the valve of the tank.
3 You could check for leaks by applying soapy water to the valve and slightly opening it. Leaking gas would cause bubbles to foam around the value. If this happens, check the valve area and the connection hose at the nut. Re-tighten the connecting nut if you detect any leaks in the valve area, and then perform the leak checking procedure again. Persistent leaks mean that both the nut and connecting hose will need to be replaced. However, if replacing the nut and hose still does not stop the leak, the tank will need to be replaced.
4 Open the valve all the way to enable the gas to fill the connecting hose. After that you could start the lift truck and resume working.